A separate drafting site 171 This entry may only be used when the material is transported in non-friable tablet form or for granular or powered mixtures that have been shown to meet the PG III criteria in 173.127. They must be classified in accordance with the procedure as set out in the Manual of Tests and Criteria, part III, section 39 (IBR, see 171.7 of this subchapter). All special provision A lighter refill exceeding 4 fluid ounces capacity (7.22 cubic inches) or containing more than 65 grams of fuel must be classed as a Division 2.1 material, described with the proper shipping name appropriate for the material, and packaged in the packaging specified in part 173 of this subchapter for the flammable gas contained therein. When a placard is displayed, the placard must be the placard shown in 172.560. Test of type 3(c) is not required. B45 Each tank must have a reclosing combination pressure relief device equipped with stainless steel or platinum rupture discs approved by the AAR Tank Car Committee. The material is also be subject to operational controls which include not exceeding a temperature of 55C (130F) at the time it is offered or during transportation, not exceeding a transportation time of 24 hours, and drivers transporting spent bleaching earth must be trained in the properties and hazards of the spent bleaching earth. a. If it is evident that a package of radioactive material, or conveyance carrying unpackaged radioactive material, is leaking, or if it is suspected that the package, or conveyance carrying unpackaged material, may have leaked, the requirements of 173.443(e) of this subchapter apply. Get the latest updates, news, and regulations for HazMat Transport and Waste Management. B16 The lading must be completely covered with nitrogen, inert gas or other inert materials. Additionally, unless otherwise excepted in this subchapter, polyester resin kits must be packaged in specification combination packagings based on the performance level of the base material contained within the kit. (1) Even though certain packagings are specified in this part, it is, nevertheless, the responsibility of the person offering a hazardous material for transportation to ensure that such packagings are compatible with their lading. Except when approved by the Associate Administrator, these items may only contain hazardous materials for which exceptions are referenced in Column (8) of the 172.101 Table and are provided in part 173, subparts D and G, of this subchapter. 181 When a package contains a combination of lithium batteries contained in equipment and lithium batteries packed with equipment, the following requirements apply: a. A54 Irrespective of the quantity limits in Column 9B of the 172.101 table, a lithium battery, including a lithium battery packed with, or contained in, equipment that otherwise meets the applicable requirements of 173.185, may have a mass exceeding 35 kg if approved by the Associate Administrator prior to shipment. The packing group assignment and packaging must be approved by the Associate Administrator for Hazardous Materials Safety on the basis of the criteria in 173.21 of this subchapter and the package type used for the Series 6(c) test. Effective January 1, 2012, for transportation by vessel, this entry may only be used if the results of Test Series 6(d) of Part I of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter) have demonstrated that any hazardous effects from accidental functioning are confined to within the package. When a plus sign is assigned to mix- (5) Each receptacle shall be able to withstand a pressure of 20 bar (2000 kPa) without leakage when the pressure relief device is deactivated. B65 Tank cars constructed before March 16, 2009, must have a test pressure of 34.47 Bar (500 psig) or greater and conform to Class 105A. TP6 The tank must be equipped with a pressure release device which prevent a tank from bursting under fire engulfment conditions (the conditions prescribed in CGA pamphlet S-1.2 (see 171.7 of this subchapter) or alternative conditions approved by the Associate Administrator may be used to consider the fire engulfment condition), taking into account the properties of the hazardous material to be transported. 140 This material is regulated only when it meets the defining criteria for a hazardous substance or a marine pollutant. N20 A 5M1 multi-wall paper bag is authorized if transported in a closed transport vehicle. B26 Tanks must be insulated. Insulating materials may not promote corrosion to steel when wet. B13 A nonspecification cargo tank motor vehicle authorized in 173.247 of this subchapter must be at least equivalent in design and in construction to a DOT 406 cargo tank or MC 306 cargo tank (if constructed before August 31, 1995), except as follows: a. Packagings equivalent to MC 306 cargo tanks are excepted from the certification, venting, and emergency flow requirements of the MC 306 specification. 55 This device must be approved in accordance with 173.56 of this subchapter by the Associate Administrator. 44 The formulation must be prepared so that it remains homogenous and does not separate during transport. Prior to repacking into the life-saving appliance, an installed inflation cylinder must successfully meet and pass all inspection and test criteria and standards of the raft manufacturer and the vessel Flag State requirements for cylinders installed as part of life-saving appliances, self-inflating (UN2990) used on marine vessels. A37 This entry applies only to a material meeting the definition in 171.8 of this subchapter for self-defense spray. They will appear as a list of codes that are defined in 172.102 of the Code of Federal Regulations. 28 The dihydrated sodium salt of dichloroisocyanuric acid does not meet the criteria for inclusion in Division 5.1 (Oxidizer) and is not subject to the requirements of this subchapter unless meeting the criteria for inclusion in another class or division. This contact form is only for website help or website suggestions. This entry also applies to articles not conforming to the requirements of 173.302, 173.304, or 173.306 of this subchapter, containing a small pressure receptacle with a release device. 368 In the case of non-fissile or fissile-excepted uranium hexafluoride, the material must be classified under UN3507 or UN2978. Each inner packaging contains not more than 30 mL; b. B115 Rail cars, highway trailers, roll-on/roll-off bins, or other non-specification bulk packagings are authorized. This content is from the eCFR and may include recent changes applied to the CFR. IBCs of type 31A and 31N are only authorized if approved by the Associate Administrator. Column 2 specifies the minimum test pressure, in bar (1 bar = 14.5 psig), at which the periodic hydrostatic testing required by 180.605 of this subchapter must be conducted. 342 Glass inner packagings (such as ampoules or capsules) intended only for use in sterilization devices, when containing less than 30 mL of ethylene oxide per inner packaging with not more than 300 mL per outer packaging, may be transported in accordance with 173.4a of this subchapter, irrespective of the restriction of 173.4a(b) and the indication of forbidden in columns (9A) and (9B) of the 172.101 table provided that: a. Packagings of other material constructed with a small amount of metal must be designed such that the hazardous material does not contact the metal. These provisions apply only to transportation by aircraft: A1 Single packagings are not permitted on passenger aircraft. b. 59 Ferrocerium, stabilized against corrosion, with a minimum iron content of 10 percent is not subject to the requirements of this subchapter. B18 Open steel hoppers or bins are authorized. B53 Packagings must be made of either aluminum or steel. Explosives shipped in conformance with this paragraph must have been examined in accordance with 173.56 of this subchapter and approved by the Associate Administrator. 4 This material is poisonous by inhalation (see 171.8 of this subchapter) in Hazard Zone D (see 173.116(a) of this subchapter), and must be described as an inhalation hazard under the provisions of this subchapter. B57 Class 115A tank car tanks used to transport chloroprene must be equipped with a non-reclosing pressure relief device of a diameter not less than 305 mm (12 inches) with a maximum rupture disc pressure of 310 kPa (45 psig). Choosing an item from Capacitors with an energy storage capacity of 0.3 Wh or less are not subject to the requirements of this subchapter. Nickel-metal hydride batteries subject to this special provision are subject only to the following requirements: (1) The batteries must be prepared and packaged for transport in a manner to prevent a dangerous evolution of heat, short circuits, and damage to terminals; and are subject to the incident reporting in accordance with 171.16 of this subchapter if a fire, violent rupture, explosion or dangerous evolution of heat (i.e., an amount of heat sufficient to be dangerous to packaging or personal safety to include charring of packaging, melting of packaging, scorching of packaging, or other evidence) occurs as a direct result of a nickel metal hydride battery; and (2) when loaded in a cargo transport unit in a total quantity of 100 kg gross mass or more, the shipping paper requirements of Subpart C of this part, the manifest requirements of 176.30 of this subchapter, and the vessel stowage requirements assigned to this entry in Column (10) of the 172.101 Hazardous Materials Table. IBCs must have a device to allow venting. A portable tank may be offered for transport after the date of expiry of the last lining inspection for a period not to exceed three months for purposes of performing the next required test or inspection, after emptying but before cleaning. b. If a package contains both lithium metal batteries and lithium ion batteries packed with and contained in equipment, then the shipping paper must indicate both UN 3091 Lithium metal batteries packed with equipment and UN 3481 Lithium ion batteries packed with equipment.. 340 This entry applies only to the vessel transportation of nickel-metal hydride batteries as cargo. Outage must be sufficient to prevent tanks from becoming liquid full at 55 C (130 F). TP45 Each portable tank must be made of stainless steel, except that steel other than stainless steel may be used in accordance with the provisions of 173.24b(b) of this subchapter. Equipment powered by lithium metal batteries or lithium ion batteries must be described using the entries Lithium metal batteries contained in equipment or Lithium metal batteries packed with equipment or Lithium ion batteries contained in equipment or Lithium ion batteries packed with equipment, as appropriate. The fiber drum must to be fabricated with a three ply wall, as a minimum. Insulation must be at least 100 mm (3.9 inches) except that the insulation thickness may be reduced to 51 mm (2 inches) over the exterior heater coils. (iii) A copy of the test results must be kept on file at each facility where packagings are offered for transportation, and must be made available to a representative of the Department upon request. Primary receptacles must be further packed in non-specification bulk outer packagings such as cubic yard boxes, plastic rigid-wall bulk containers, dump trailers, and roll-off containers. Others such as copper and silver are available in trace amounts. 164 Substances must not be transported under this entry unless approved by the Associate Administrator on the basis of the results of appropriate tests according to Part I of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter). No Class 7 label is required to be displayed. citations and headings B35 Tank cars containing hydrogen cyanide may be alternatively marked Hydrocyanic acid, liquefied if otherwise conforming to marking requirements in subpart D of this part. Components classed as Division 6.1, Packing Group I, or Class 8, Packing Group I, must not be offered for transportation and transported under this description. The examination and testing of each lighter design must be performed by a person authorized by the Associate Administrator under the provisions of subpart E of part 107 of this chapter, as specified in 173.308(a)(4).
Dallas Piano Competition,
Lakers Revenue Breakdown,
Courtney Brooke Wagner Net Worth,
Articles C